Home > News > Content
How To Improve The Quality Of Fine Wire Staple (19-23 GA.)
- Jun 22, 2017 -

How to improve the quality of Fine Wire Staple (19-23 GA.)
   (19-23 GA) The advantage of hot-dip galvanizing is that the mechanical properties of the Fine Wire Staple (19-23 GA.) are poor and the strength is reduced and the toughness is reduced. Therefore, the quality of the Fine Wire Staple (19-23 GA.) is inferior to that of fine Fine Wire Staple (19-23 GA.). How to improve the quality of Fine Wire Staple (19-23 GA.)?
    When the Fine Wire Staple (19-23 GA.) are drawn with a pre-plated zinc wire, the mechanical properties do not occur. The toughness of this fine spike (19-23 GA) is 15 to 25 percent higher than that of the galvanized galvanized, and in some cases it is even slightly more than the light fine spike (19-23 GA ) Toughness.
    (19-23 GA), the strength limit is higher than the first high after plating, plated with zinc and then made of Fine Wire Staple (19-23 GA.) not only toughness and strength high. (19-23 GA) in the strength of the limit so there is a relatively low number, which is due to zinc because of the strength of zinc technology than the Fine Wire Staple (19-23 GA.) itself small times The
    It is difficult to hot galvanize the Fine Wire Staple (19-23 GA.), and it is less likely that the finer and very fine Fine Wire Staple (19-23 GA.) are plated with a smooth zinc layer of the desired thickness. The finest Fine Wire Staple (19-23 GA.) are small and relatively large, so the degree of erosion is greatest, but the quality of the finishes is particularly thin. If the first plated with zinc and then pull out, finished Fine Wire Staple (19-23 GA.) on the zinc layer of Baidu can be adjusted.
    On the finest Fine Wire Staple (19-23 GA.), the thickness of the zinc layer after the first plating is greater than 100% higher than that of the first. This will improve the quality of the Fine Wire Staple (19-23 GA.).
   The general hardware and machinery plants produce Fine Wire Staple (19-23 GA.) or use Fine Wire Staple (19-23 GA.) equipment to produce galvanized Fine Wire Staple (19-23 GA.) according to customer requirements. Fine Wire Staple (19-23 GA.) and general Fine Wire Staple (19-23 GA.) are very different, and generally Fine Wire Staple (19-23 GA.) are inexpensive, and because iron is not very stable and is easy in wet places Rusty, so the stability is not very good, life is not very long; Fine Wire Staple (19-23 GA.) in the Fine Wire Staple (19-23 GA.) coated with a layer of stable zinc, with zinc layer to protect the fine Threads (19-23 GA) make the service life of Fine Wire Staple (19-23 GA.) longer. Therefore, the machinery plant must learn to use Fine Wire Staple (19-23 GA.) equipment.

    Fine nail (19-23 GA) equipment before use there is a very important step is to pickling iron, pickling is to use some acid mist or acid wash iron surface of some oxides, that is, rust, There are some other corrosive substances, to achieve the purpose of cleaning iron, so that when the zinc will cause zinc off. Pickling time to pay great attention to the acid has a strong corrosive, so ye add acid when the acid must be poured into the water, and is along the cylinder wall, can not be poured down, so as to avoid splashing.

Copyright © Shaoxing Pengfei Bedding Nail Co.,Ltd All rights reserved.